©Copyright 2009 IonWays, LLC VS.1
Page 7
Installation of IonWays UnderSink Kit (Optional
)
Included in your new under sink kit is:
1.) (1) Patent Pending double spouted faucet
2.) (1) Metal Cold Water Connector w/ Shut off
(Connect to Cold Water) ASVPP1
3.) (1) Alternate Color Faucet Base
4.) (1) Light Grey 90
o
Fitting
(Connect to Acidic Spout)
5.) (1) Dark Grey Threaded Fitting
(Connect to Alkaline Spout)
Attaching to cold water pipe:
1.) You will want to maintain access to the Control Panel on the ionizer. Place the ionizer close to the front of
the cabinet. A template is included for installation on the cabinet wall if you desire.
2.) Attach the threaded fitting for the Alkaline Spout (see drawing above) into the top of your ionizer as a
replacement for the flexible stainless steel tube. (Do not over-tighten, if needed use Teflon tape)
3.) Push the larger sized opening on the 90
o
Acid Spout fitting onto the Acidic Water Outlet.
4.) Install the faucet into an existing hole, or by cutting an inch and a half hole in your counter top, or sink.
(be sure that the faucet will clear the sink)
5.)
Turn off your cold water supply line
. Attach the cold water connecter to the cold water supply line.
Hooking up the faucet:
1.) Drill 1 ½” hole in countertop if one does not already
exist. Typically the hole for a soap dispenser can
also be used.
2.) Install the faucet and base plate on top of counter
3.) One BLACK line goes to the Remineralizing
Cartridge (Stage 4 in R/O diagram, page 3)
4.) The other BLACK one goes to the water inlet on the
ionizer. The two black lines are interchangeable.
5.) The
BLUE
goes to the alkaline top spout.
6.) The
RED
goes to the acidic outlet.