ionmax ION622, User Manual

Page: 13 / 16

The unit is defrosting (the
indicator is blinking)
TROUBLESHOOTING
Please contact your retailer if any problem continues. Do not try to repair the unit yourself, as
as this could cause an electrical shock and void your warranty.
Problem
Dehumidifier
not operating
Leaking
Very little
water is
collected
The unit is unplugged
into the electrical outlet.
Make sure the plug is pushed completely
Empty the water tank, check that the float is
in position, and reinstall the water tank.
This is normal. The unit will restart its operation
after it has finished defrosting.
The ambient temperature is too
Air filter is dirty
The air inlet or outlet is covered
Clean the filter.
Ensure nothing is obstructing the unit’s air
inlets and outlets and that the unit is set up
correctly according to the Unit Setup guide.
low (the unit is defrosting
often)
The ambient temperature is
too high that it causes
overheating
This is normal if the temperature is low.
Do not use the unit in small and closed
spaces where heat may accumulate. Move
the unit to a cooler place and wait at least
10 minutes before resuming operation.
The unit is not level
surface and not accidentally sitting on a
Ensure that the unit is placed on a level
cable etc.
The drainage is clogged or
loose
connection.
Check the drainage hose and its
The water tank is full or not in
place (the indicator is blinking)
The room humidity has reached
the setting
This is normal. Choose a lower relative
humidity setting (e.g. 40%RH) for drier air.
Possible Causes What to Do
The following conditions are normal:
1.
The compressor will stop or rest for 3 minutes every time the unit shuts down or is
plugged in to the electrical outlet. This helps ensure a smooth start for the dehumidifier.
2. The unit works within room temperature of about 5 ~ 35ºC. It may stop operation when
the room temperature is out of this range or when the air inlet or outlet is covered.
3. The unit could increase the room temperature by 1 ~ 3ºC.
If your dehumidifier is not operating as expected, please check the following items first:
Unit is noisy
Unit is not on a flat and level
surface
Air filter is dirty
Move and restart the unit.
Clean the filter.
11