26
Securing the sensor
In order to compress the black square ring, the sensor must be secured so that you can
apply downward pressure to compress the ring. This can be done by holding in your
hand, using a vise, or using pliers, as detailed below.
By Hand - cabled version only
1. Tightly grasp the top cap in one hand.
2. Brace your hand against something such as a table or the ground. (Do not allow
the cable to be pinched against the brace.)
Continue to
Removing the Housing
on the next page.
With Vise - recommended method
Cabled Sensor
1. If possible, use a set of soft jaws
as shown to prevent marring the
surfaces of the top cap assembly.
2. Place the sensor in a vise clamping
gently on the swaged area. You
do not need to clamp the vise very
hard.
Continue to
Removing the Housing
on the next page.
Cableless Sensor
1. If possible, use a set of soft jaws
as shown to prevent marring the
surfaces of the top cap assembly.
2. Remove the cableless top cap.
3. Place the sensor in a vise clamping
gently on the knurled area. You
do not need to clamp the vise very
hard.
Continue to
Removing the Housing
on the next page.
Cabled Sensor - gripping on swage
Cableless Sensor - gripping
on knurled area
