Goodrive600 series high-performance multifunction VFD
Function parameter list
-251-
Function
code
Name
Description
Default Modify
or decreases linearly.
fmax
Output frequency f
Time t
1: S curve. The output frequency increases or
decreases according to the S curve.
The S curve is generally applied to elevators,
conveyors, and other application scenarios
where smoother start or stop is required.
Output frequency f
Time t
fmax
Note: When the function parameter is set to
1, you also need to set P01.06, P01.07,
P01.06
Time of starting
segment of ACC S
curve
The curvature of S curve is determined by the
ACC range and ACC/DEC time.
Output frequency f
Time t
t1
t2
t3
t4
t1=P01.06
t2=P01.07
t3=P01.27
t4=P01.28
Setting range: 0.0
–50.0s
0.1s
◎
P01.07
Time of ending segment
of ACC S curve
0.1s
◎
P01.08
Stop mode
0: Decelerate to stop. After a stop command
takes effect, the inverter unit lowers output
frequency based on the DEC mode and the
defined DEC time; after the frequency drops to
the stop speed (P01.15), the inverter unit stops.
1: Coast to stop. After a stop command takes
effect, the inverter unit stops output immediately.
and the load coasts to stop according to
mechanical inertia.
0
○
P01.09
Starting frequency of
DC braking for stop
Starting frequency of DC braking for stop: During
the deceleration to stop, the VFD starts DC
braking for stop when running frequency reaches
the starting frequency determined by P01.09.
Wait time before DC braking: The inverter unit
blocks the output before starting DC braking.
After this wait time, DC braking is started so as to
0.00Hz
○
P01.10
Demagnetization time
0.00s
○
P01.11
DC braking current for
stop
0.0%
○
P01.12
DC braking time for stop
0.00s
○
