Using Relay Outputs to Control Wired Devices
11
The relay outputs labeled “Out 1” and “Out 2” located on the left side
of BlueSwitch enable the user to connect and control wired devices
such as a nurse call button. The relays support a maximum of 1 amp of
current and 30 volts DC. Exceeding these specifications will damage
BlueSwitch.
To control the relays, cycle through connected Bluetooth devices until
the Device LEDs on the front of BlueSwitch are all green. Switch
activations will then be sent to the relay outputs. If no Bluetooth
devices are connected to BlueSwitch, switch activations are
automatically sent to the relays. SW1 activations are set to “Out 1”
and SW2 activations are sent to “Out 2”.
Questions
If you have any questions about BlueSwitch, please don’t hesitate to
contact us.
Phone: 479-632-4166
Email: [email protected]
Address: 1026 Riverview Dr.
Alma, AR 72921
Phone: 479-632-4166
Email: [email protected]
Rev. 1