Right Side of BlueSwitch
3
Charging Port
The Micro-B USB jack labeled “CHG” is used to charge the device.
When the provided USB cable is connected and powered, the device
will charge. On the front of BlueSwitch is a battery symbol with four
LEDs that display the current battery status. When the device is
charging, a battery LED will blink.
Unpair Button
This button is used to disconnect BlueSwitch from
all Bluetooth devices. This includes forgetting all
the devices which BlueSwitch attempts to
reconnect to on power up. To do so, hold down
the Unpair button for three seconds until a long
beep is heard.
On/Off Switch
The switch labeled “ON” is the on/off switch. To
turn the device on, slide the switch upward
towards the DIP switches. To turn the device off,
slide the switch downward towards the charging
jack. A green LED above the switch also indicates
when the device is turned on.
DIP Switches
The light-blue DIP switches enable switching
among basic configurations without using the
BlueSwitch Android app. These configurations are
discussed in detail in the section “DIP Switch
Settings”.
Front of BlueSwitch
4
Active Sw. LED
The Active Sw. LED glows green when SW1 is activated, red when SW2
is activated, and orange when SW3 is activated. The Active Sw. LED will
blink orange when attempting to auto-reconnect to previously
connected Bluetooth devices.
Device 1/2/3 LEDs
These LEDs indicate when
Bluetooth
devices
are
connected to BlueSwitch. Each
LED will glow green when that
device
is
connected.
The
device’s LED glows orange when
it is selected as an output device
for switch activations. If all the
device’s LEDs are green or no
Bluetooth
devices
are
connected, switch activations
are sent to the relay outputs
instead of to a Bluetooth device.
Battery Symbol
The battery symbol has four LEDs that display the battery power
status. When the device is charging, a battery LED will blink.
Figure 2:
Right View
Figure 3:
Front View