INVOLAR Corporation, Ltd.
Manual version 1.12
INVOLAR Corporation Ltd. Mar. 2016
22
5
INVOLAR MAC500 Installation
WARNINGS
: In case of installation in PV system, startup of the unit (i.e.
start of designated operation) is prohibited until it is determined that the
full system meets the requirements stipulated in the EC Directive
(2006/95/EC,
2004/108/EC
etc.).
The
grid-Connected Inverter
leaves the factory completely connecting
device and readyfor connection to the mains and PV supply. The unit
shall be installed in accordance withnational wiring regulations.
Compliance with safety regulations depends upon installingand
configuring system correctly, including using the specified wirings. The
system mustbe installed only by professional assemblers who are familiar
with requirements for safetyand EMC. The assembler is responsible for
ensuring that the end system complies with allthe relevant laws in the
country where it is to be used.
The individual subassembly of the system shall be interconnected by
means of the wiring methods outlined in national/international
regulations but not limited tothe BS7671 Requirements/ VDE regulation
0107.
To ensure the safe operation of the devices, they may be installed and
commissioned only by qualified personnel in full compliance with the
warnings referred to in this manual.
Open the package and pick the product, check that if there is any
distortion or impaired during transportation, meanwhile, check that if all
the relating accessories and materials are here, you can see the
accessories list in the “Appendix”.
The instruction manual is an integral part of the unit
and should
therefore be read and kept carefully.
It is recommended
that the packaging should not be removed until the
unit is located in the installation site.
Do not dispose of packaging materials
in the environment or leave
them within reach of children as they may represent a hazard
Check that there are no signs of damage. Before attempting
installation and operation, check the information on the type
designation label of the unit to verify that the unit is of the correct type.
The label includes an IEC rating and CE markings, a type code and a
serial number, which allow individual recognition of each unit.
Check the mechanical and electrical installation of the unit before
startup. Go through the checklist below together with another person.
Read the sections “Safety instruction and EC Directives”
and “
Interface
protection and Inverter setpoints’ on the previous pages of this manual