2
Foreword
This document contains important information regarding the installation and operation of
the ICT 801, ICT 802, and ICT 810 Transmitters, and the R21 v4.0 Titanium Computer
Collar
®
. Prior installation of signal field wire is assumed. Review all instructions before
installation and use.
System Information
The ICT 801, ICT 802, and ICT 810
Transmitters are used as part of an Invisible
Fence
®
Brand pet containment system. These
transmitters must always be installed in a dry,
protected area to insure they will not be
exposed to the elements.
The transmitters are connected to an external signal field wire and send a coded, digital
signal along the entire length of wire. The following wire specification should be
followed:
ICT 801 / ICT 802
Up to 3,000 ft.
ICT 810
Up to 5,000 ft.
Feet of twisted pair
150 feet
200 feet
Wire size
14 AWG
12 AWG *
Jacket
PE .045”
PE .045”
*
12 AWG is recommended, however, it may require a pigtail to 14 AWG for insertion
into the LP-4100 or LP-4200 connectors.
The ICT 801 and ICT 802 are programmable to transmit a digital signal either at 7KHz
or at 10KHz, whereas the ICT 810 transmits only a 7KHz digital signal.
The ICT 801,
ICT 802, and ICT 810 Transmitters are only compatible with the R21 v4.0 Titanium
Computer Collar
®
.
All ICT 801, ICT 802, and ICT 810 Transmitters have removable
circuit boards that can be replaced if damaged.
Planning the Installation
Install the transmitter in a dry indoor location, near a grounded 110VAC electric outlet
that offers easy access to the outdoors. A garage or basement is usually the best
location.
If you are not sure the intended outlet is grounded, use a 3-wire circuit
analyzer or contact an electrician.
To fasten the transmitter base to the wall, you
need four ¾ inch long (19mm), #8, or #10 pan-head sheet metal screws.
Caution: Never install a system or equipment, or service any equipment, during a
thunderstorm or electrical storm, or when thunder or lightning is in your area.