Inverto IDL 7000m TCX, User Manual

Page: 15 / 125

14
4.1.1.10. EPG font size
This option allows you to change to size of the text in the EPG, to allow you to see more or less data at once. Select this option with
the “OK” key (6) or “Left” and “Right” directional keys.
4.1.1.11. Power Up Mode
This option allows you to set the unit to automatically change to a specific mode during power-up. If you select “Stand-by mode”, the
receiver will go into stand-by immediately after power-up. If you select “Last mode”, the receiver will change to the same mode it was
in, prior to switching it off. Select this option with the “OK” key (6) or “Left” and “Right” directional keys.
Note:
Digital receiver is able to switch on some of the TV sets that use the “Slow Blanking” signal on a SCART connector. If “Last Mode” is
selected, the receiver and TV will power-up again, after a power failure. .
4.1.1.12. Auto Upgrades
By choosing “Notify”, you will see a symbol in the upper part of the OSD when a new update is available. Select this option
with the “OK” key (6) or “Left” and “Right” directional keys.
4.1.1.13. Zapping Screen
With this option, you can define if zapping will be on the main screen or in
PIP (Picture In Picture). This option is valid only if PIP mode is activated.
Select this option with the “OK” key (6) or “Left” and “Right” directional keys.
4.1.2. Audio/Video Settings
This is where you can set the basic audio and video parameters of your
digital receiver related to connections on rear panel (see picture 15).
4.1.2.1. TV SCART
Use this option to specify video output type on the TV SCART connector.
Select this option with the “OK” key (6) or “Left” and “Right” directional keys.
CVBS (composite) – Signal is available on the SCART connector (13) as
well as on the “Video output” connector (10).
S-Video – Signal is available on the SCART connector (13) as well as on the
“S-Video” connector (12).
RGB – Signal is available only on the SCART connector (13)
YUV – Signal is available only on the SCART connector (13)
4.1.2.2. VCR SCART
Use this option to specify the video output type on the VCR SCART connector. You may select CVBS (composite) or S-Video for the
VCR SCART connector (14). Select this option with the “OK” key (6) or “Left” and “Right” directional keys.
4.1.2.3. Aspect Ratio
Use this option to specify the screen ratio of the connected TV set. Select this option with the “OK” key (6) or “Left” and “Right”
directional keys.
4:3 – Select this option, if you have a standard TV with automatic format detection
16:9 – Select this option if you have a wide-screen TV
4:3 Letterbox – Select this option to convert a standard 4:3 video to 16:9. This is normally used to display a video in wide-screen
format on a standard TV that does not have automatic format detection.
Picture 15