Extended Parameters
Par.
Description
Min
Max
Default
Units
P-15
Digital Input Function Select
0
17
0
-
P-16
Analog Input 1 Signal Format
See Below
U0-10
-
U
: Unidirectional, External 0 – 10Volt reference / pot
B
: Bi-directional, External 0 – 10Volt reference / pot
: External 0 – 20mA signal
4
: External 4-20mA signal, trip on loss
r 4
: External 4 – 20mA signal
4
: External 20 – 4mA signal, trip on loss
r 4
: External 20 – 4mA signal
U
: External 10 – 0 Volt signal
n
:
Switched units only
: Internal pot
P-18
Output Relay Function Select
0
9
1
-
0: Drive Enabled (Running)
1: Drive Healthy
2: At Target Frequency (Speed)
3: Drive Tripped
4: Output Frequency >= Limit
5: Output Current >= Limit
6: Output Frequency < Limit
7: Output Current < Limit
8: Analog Input 2 > Limit
9: Drive Ready to Run
P-20
Preset Frequency / Speed 1
-P-01
P-01
5.0
Hz/RPM
P-21
Preset Frequency / Speed 2
-P-01
P-01
25.0
Hz/RPM
P-22
Preset Frequency / Speed 3
-P-01
P-01
40.0
Hz/RPM
P-23
Preset Frequency / Speed 4
-P-01
P-01
P-09
Hz/RPM
P-24
2nd Ramp Time (Fast Stop)
0.00
600.0
0.00
s
P-25
Analog Output Function Select
0
11
8
-
Digital Output Mode. Logic 1 = +24V DC
Analog Output Mode
0: Drive Enabled (Running)
1: Drive Healthy
2: At Target Frequency (Speed)
3: Drive Tripped
4: Output Frequency >= Limit
5: Output Current >= Limit
6: Output Frequency < Limit
7: Output Current < Limit
8: Output Frequency (Motor Speed)
9: Output (Motor) Current
10: Output Power
11: Load Current
P-31
Keypad Start Mode Select
0
7
1
-
0: Minimum Speed, Keypad Start
1: Previous Speed, Keypad Start
2: Minimum Speed, Terminal Enable
3: Previous Speed, Terminal Enable
4: Current Speed, Keypad Start
5: Preset Speed 4, Keypad Start
6: Current Speed, Terminal Start
7: Preset Speed 4, Terminal Start
P-33
Spin Start
0
2
0
-
0: Disabled
1: Enabled
2: Enabled on Trip, Brown Out or Coast Stop
P-34
Brake Chopper Enable (Not Size 1)
0
4
0
-
0: Disabled
1: Enabled With Software Protection
2: Enabled Without Software Protection
3: Enabled With Software Protection
4: Enabled Without Software Protection
P-38
Parameter Access Lock
0
1
0
-
0: Unlocked
1: Locked
P-39
Analog Input 1 Offset
-500.0
500.0
0.0
%
P-40
Index 1: Display Scaling Factor
0.000
16.000
0.000
-
Index 2: Display Scaling Source
0
3
0
-
P-41
PI Controller Proportional Gain
0.0
30.0
1.0
-
P-42
PI Controller Integral Time
0.0
30.0
1.0
s
