7
Battery Modes
LED Status
LED Indicator Status
SOC
81 – 100%
61 – 80%
41 – 60%
21 – 40%
11 – 20%
1 to 10%
Note: CAN lines in the battery pack DO NOT
have internal termination resistance. It is
recommended to properly terminate the system
and battery CAN Bus lines following the CAN
Bus termination standards. For any technical
questions about properly adding termination
resistance, please contact technical support at
[email protected].
Sleep Mode
Disconnect pins 4, 5 & 6
to put into Sleep Mode
Charge Mode
Connect pins 4 & 6
to enter Charge Mode
Discharge Mode
Connect pins 5 & 6
to enter Discharge Mode
1
2 3
4 5
6
7 8
1
2 3
4 5
6
7 8
1
2 3
4
5
6
7 8
Mode Name
VWAKE
VINTLK
Action
Mode Description
Sleep
Off
(High or Hi-z)
Off
(High or Hi-z)
Disconnect pins 4, 5, and
6 to enter Sleep Mode
Low power mode,
MOSFETs open
Charge
Off
(High or Hi-z)
On
(Low)
Connect pins 4 and 6 to
enable charging
Charge allowed*,
MOSFETs closed
Charge
On
(Low)
On
(Low)
Connect pin 6 to pins 4
and 5 to enable charging
Charge allowed*,
MOSFETs closed
Discharge
On
(Low)
Off
(High or Hi-z)
Connect pins 5 and 6 to
allow discharging
Discharge allowed**,
MOSFETs closed
Ship
Off
(High or Hi-z)
N/A
Press the SOC button
and hold for 20 sec
Low power mode,
MOSFETs open
Shutdown
N/A
N/A
Apply charge voltage to
exit Shutdown
Lowest power mode,
MOSFETs open
