how to operate the appliance
4
THERMOSTAT SETTING
The thermostat automatically regulates the inside temperature of the compartments.
By rotating the knob from position 1 to 5, colder temperatures can be obtained.
Note:
rotating the knob beyond position 1 to “�“ will stop the appliance.
FREEZER AND REFRIGERATOR THERMOSTAT SETTING
1-2:
for short-term storage of food in the freezer compartment, you can set the knob between the minimum and medium
position.
3-4:
for long-term storage of food in the freezer compartment, you can set the knob to the medium position.
5:
for freezing fresh food. The appliance will run for colder temperatures.
Set the thermostat on setting 3. The appliance now cools continuously until the set temperature has been reached. Do not place
anything in the refrigerator until the set temperature is reached. This usually takes 2 or 3 hours. Then set the thermostat at the desired
setting and place food into the refrigerator.
FOR A+ MODELS
The freezer compartment, marked with the
symbol, is used for storing frozen food and freezing fresh or cooked food. It also
allows the making of ice cubes.
Attention:
The ambient air temperature, how often the door is opened and the position of the appliance can affect the internal temperature.
These factors must be taken into account when setting the thermostat.
• Never introduce volatile, inflammable or explosive fluids such as alcohol, acetone or petrol because of the risk of explosion.
• A 5 minute delaying function is applied to prevent damage to the compressor of your appliance, when you take the plug out and
then plug it in again to operate it or when an energy breakdown occurs. Your appliance will start to operate normally after 5 minutes.
before the first use
3
Leave the appliance to stand for at least 3 hours before you insert the plug into the socket. Otherwise, you may damage the
compressor.
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the appliance after unpacking for any
damage, possible from transportation. Place the appliance on a flat and stable surface. Clean the appliance thoroughly, especially in
the interior, before use (see Cleaning & Maintenance).
The installation procedure is given in the Installation Instructions.
The appliance must be connected with a properly installed fused socket. The power supply (AC) and voltage at the operating point
must correspond with the details on the rating label of the appliance. The rating label is located on the inside left of the appliance.
There can be an odor when you first switch on the appliance. It will disappear after the appliance starts to cool.
Install the plastic distance guide by turning it 90° as shown in the figure to prevent the condensor from touching
the wall.
To ensure well functioning of your appliance make sure the adjustable front legs are adjusted so your appliance is
level and stable. You can adjust the legs by turning them clockwise (or in the opposite direction). This should be
done before placing food in the appliance.
First clean the interior of the appliance. Use warm water and a neutral detergent. After cleaning, rinse the interior with clean water and
rub dry. Leave the appliance to dry for 1 to 2 hours.
English
•
25
Summary of Contents for IKK0821D
