inventum AKO6015ZWA, User Manual

Page: 29 / 68

UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.
PREPARING FOR INSTALLATION
1. Mark the wall/ kitchen cabinet from the middle of the hob. Make sure that you keep the
minimum distance between the hob and the appliance into account plus the height of the
appliance (A).
2. Determine whether you want the appliance extracting or recirculating the cooking fumes.
Note:
Follow the steps in chapter
'Preparing the appliance for recirculation'
to prepare the appliance for
recirculation, otherwise keep following the steps below.
3. Determine the position of the hose. Saw out an opening (F) for the hose.
Note:
The diameter of the hose is 150 mm. The opening must be 10 mm larger than the hose (160 mm).
4. Attach the hose to the extraction duct and allow it to hang down.
PREPARING THE INSTALLATION OF THE HOSE FOR EXTRACTION MODE
The hose can be installed either via the wall or via the ceiling.
Preparing the installation of the hose via the wall
1. Drill a hole (A) in the wall with a diameter of 160 mm.
Preparing the installation of the hose via the ceiling
1. Drill a hole (A) in the ceiling with a diameter of 160 mm.
2. Make sure that the hole is positioned a minimum of 100 mm (B) from the wall.
PREPARING THE INSTALLATION OF THE MAINS SOCKET
1. Mark the position for the mains socket.
Place the mains socket inside the kitchen cabinet or just above it.
Make sure you can reach the plug when necessary after installation.
HOW TO INSTALL THE APPLIANCE - 3 OPTIONS
1. Mount to the wall, in case there is no kitchen cabinet.
2. Mount to the bottom of a kitchen cabinet.
3. Mount to the wall and the bottom of the kitchen cabinet.
(Figure 4)
(Figure 5)
(Figure 6)
English • 29