5
U S E R A N D S A F E T Y I N S T R U C T I O N S
iV14-Zero ventilation system
•
Installation instructions
)
*
+
Safety instructions
These installation instructions are part of the ventilation unit and must be permanently avail-
DEOH:KHQKDQGLQJWKHHTXLSPHQWV\VWHPWRDWKLUGSDUW\WKHLQVWDOODWLRQLQVWUXFWLRQVPXVW
be handed over also. Before performing any work on the system, read the installation instruc-
tions carefully and observe all information regarding installation and assembly contained in
this section. Also note the safety instructions that precede the described handling instructions.
1RQREVHUYDQFHRIVDIHW\ZDUQLQJVFRXOGUHVXOWLQLQMXU\DQGRUSURSHUW\GDPDJH
Intended use
The ventilation unit is designed to ventilate dwellings and similar residential spaces.
It is controlled via an inVENTer system controller.
General instructions
• Observe the relevant standards, regulations and guidelines, especially the applicable
EXLOGLQJFRGHVDQG¿UHDQGDFFLGHQWSUHYHQWLRQUHJXODWLRQVLVVXHGE\WKHUHVSHFWLYHWUDGH
association.
•
8VHWKHHTXLSPHQWV\VWHPH[FOXVLYHO\IRUWKHDSSOLFDWLRQVWKDWDUHGHVFULEHGLQWKLVGRFX
-
PHQWDWLRQDQGRQO\LQFRQMXQFWLRQZLWKFRPSRQHQWVWKDWDUHUHFRPPHQGHGDXWKRULVHGDQG
GHVFULEHGE\LQ9(17HU*PE+LQWKLVGRFXPHQWDWLRQ&KDQJHVRUPRGL¿FDWLRQVWRWKHHTXLS
-
PHQWV\VWHPDUHQRWSHUPLWWHG
• Your ventilation unit is exclusively designed for use in ambient temperatures between
-20 and 50 °C.
• Trouble-free and safe operation of the equipment depends on proper transportation, proper
storage and installation as well as careful operation and maintenance.
Assembly and installation
•
&$87,21,QVWDOODWLRQRIWKHV\VWHPPD\RQO\EHSHUIRUPHGE\TXDOL¿HGSHUVRQQHO
• Before starting work, you should have a ventilation concept from which the number of ventila-
tion units, their position, the ventilation principle (cross ventilation, individual room ventilation,
extraction) and the relevant controllers can be determined. The exact positioning of the units
and controllers must be determined on-site and, if necessary, adapted to the local conditions
E\WKHXVHUSODQQHU,QVWDOODWLRQLVUHFRPPHQGHGLQDVXLWDEOHSRVLWLRQLQWKHXSSHUZDOODUHD
for optimal operation.
• WARNING:
,QVWDOODSUHVVXUHPRQLWRULQURRPVZLWKRSHQÀXHV,QDQ\FDVHDLUH[FKDQJH
PXVWEHDVVXUHGWREHVXႈFLHQWIRUWKHYHQWLODWLRQXQLWVDVZHOODVWKH¿UHSODFH&RQVXOW\RXU
FKLPQH\VZHHSHUDQGRUEXLOGLQJSODQQHUEHIRUHLQVWDOODWLRQ
• NOTICE:
The ventilation unit must not be used for drying out buildings. It must not be put
into operation until after completion of the construction work. The ventilation unit must remain
sealed against dust during the construction work (attached protective discs).
• NOTICE:
'RQRWSODFHWKHXQLWQHDUUDGLDWRUVURRPWKHUPRVWDWVRULQWKHLPPHGLDWHYLFLQLW\
above sensitive paintings or furnitures.
• NOTICE:
Observe the predetermined minimum distances on both sides of the wall and in
front (see
, page 15) to avoid the mixing of outdoor air and exhaust air, and to ensure
access to the unit and its components.
• NOTICE:
Install the wall sleeve outside airtight and inside vapour tight into the air resistance
layer. Material must be provided by the customer. After installing the wall sleeve replace the
wall structure as far as the wall sleeve and observe the necessary barrier levels in order to
avoid the interruption of the thermal insulation composite system. Consult your planner!