inVENTer 1505-0036, Setup

Page: 12 / 24

Step 3: Ending component pairing on the controller
After all components are paired, the pairing must be completed, if
• less then 16 components are paired, or
• time limit of 5 minutes after pairing activation on the controller is not exceeded.
 Press the mode key to confirm the
paired components. (1)

The display screen shows the
information that the paired system
components (inner covers, external
sensors, switching contact) send to the
controller.

The system operates in the default
profile (factory settings).
Display screen
Time
Ventilation profile:
Default (can be modified)
Ventilation level
Ventilation mode
Heat recovery
Unidirectional
ventilation
Pause / Off
System display:
via sensor technology
transmitted values to
the controller system
Status
1 25 %
Air flow
volume
2 35 %
3 50 %
4 100 %
Ventilation system operates with
the pre-set ventilation profile
Ventilation system is paused
Ventilation system in Boost fuction