SECTION 8—BASE FRAME
60
Removing/Installing the Wheelchair Shrouds
NOTE: For this procedure, refer to FIGURE 8.5 on page 61.
NOTE: The following tools are required to perform this procedure.
•
Phillips Head Screwdriver
•
5/16-inch Allen Wrench
Top Shroud
NOTE: Reverse this procedure to install the top shroud.
1.
Remove the seat from the base frame.
2.
Remove the four 10-32 X 1/2-inch pan head screws securing the top shroud to the base frame.
3.
Lifting up, remove the top shroud from the base frame.
Rear shroud
NOTE: Reverse this procedure to install the rear shroud.
1.
Remove the three 10-32 X 1/2-inch pan head screws, thumb screw or lock knob securing the rear shroud to the base
frame.
2.
Remove the rear shroud from the base frame.
Front Shroud and Battery Retention Bracket
NOTE: Reverse this procedure to install the front shroud and battery retention bracket.
NOTE: The front shroud and battery retention bracket are removed from and installed onto the wheelchair frame as a single unit.
1.
Remove the two 5/16-18 X 5/8-inch socket head screws securing the front shroud/battery retention bracket to the base frame.
2.
Lift up to unhook the battery retention bracket from the base frame and remove the front shroud/battery retention
bracket from the base frame.
3.
If necessary to replace the front shroud or the battery retention bracket, perform the following:
A. Remove the four #8-16 X 5/8-inch Phillips screws securing the battery retention bracket to the front shroud.
B. Separate the front shroud from the battery retention bracket.
C. Discard the item to be replaced and replace with new front shroud or battery retention bracket.
D. Using four #8-16 X 5/8-inch Phillips screws, secure front shroud to the battery retention bracket.
