Troubleshooting
4 Troubleshooting
4.1
Error diagnosis
If the electronic system shows a fault, please use the following
fault-finding guide to locate the fault.
Ensure that the drive electronics system is switched on
before starting any diagnosis.
If the status display is OFF:
•
Check whether the drive electronics system is SWITCHED ON.
•
Check whether all cables are correctly connected.
•
Ensure that the batteries are not discharged.
If a fault number is displayed in the status display:
•
Please proceed to the next section.
4.1.1
Error codes and diagnosis codes
The drive electronics system is able to correct some errors automatically. In this case, the code number in the status display will disappear. To do
this switch the remote on and off several times. Wait approx. 5 seconds each time before switching the remote on again. If the error is not
corrected by this process, localise the error using the code numbers listed below.
CODE
NUMBER
FAULT
IMMEDIATE MEASURE
FURTHER HELP
1
Module defective.
-
•
Disconnect batteries.
1
•
Contact your dealer.
2
Seat not at driving height
If the lifter is raised, lower it in stages until the
status display goes out. If the lifter is lowered
too far, raise the lifter in stages until the status
display goes out. Only drive when the seat is
at driving height!
-
Accessory error
-
•
Disconnect batteries.
1
•
Contact your dealer.
3
Fault in left-hand motor.
Connection loose/defective
or motor defective.
Check connecting plugs.
•
Disconnect batteries.
1
•
Contact your dealer.
1528090-G
21
