44
FIGURE 1 - REMOVING/INSTALLING THE CRUTCH/
CANE HOLDER
Crutch/
Cane
Holder
Accessory
Tube
Mounting
Screw
Base
Hook
Seat
REMOVING/INSTALLING THE
SAFETY FLAG (FIGURE 2)
NOTE: To remove, reverse the following proce-
dure.
WARNING
The installation of the safety flag onto the back
of the wheelchair seat significantly increases
the length of the wheelchair. When turning
the wheelchair or swiveling the wheelchair
seat, it is important to take note of this in-
creased length - otherwise, injury and/or dam-
age to the surrounding property may result.
Installing
1. Install the bracket into the accessory tube lo-
cated on the back of the seat.
2. Install mounting screw to secure the bracket
in place. Securely tighten.
3. Install safety flag into bracket.
FIGURE 2 - REMOVING/INSTALLING THE SAFETY
FLAG
Accessory
Tube
Mounting
Screw
Bracket
Safety
Flag
Seat
This Procedure Includes the Following:
Removing/Installing the Crutch/Cane Holder
Removing/Installing The Safety Flag
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure that all attaching hard-
ware is tightened securely - otherwise injury or
damage may result.
For the following procedures, make sure the
ON/OFF switch on the joystick is in the OFF
position.
REMOVING/INSTALLING THE
CRUTCH/CANE HOLDER
(FIGURE 1)
NOTE: To remove, reverse the following proce-
dure.
WARNING
The installation of the crutch/cane holder onto
the back of the wheelchair seat significantly
increases the length of the wheelchair. When
turning the wheelchair or swiveling the
wheelchair seat, it is important to take note
of this increased length - otherwise, injury and/
or damage to the surrounding property may
result.
Installing
1. Install the crutch/cane holder into the acces-
sory tube located on the back of the seat.
2. Install mounting screw to secure the crutch/
cane holder in place. Securely tighten.
3. Align slot on base with hook on crutch/cane
holder and slide base down into position.
OPTIONS
PROCEDURE 12
Slot
O
P
T
I
O
N
S
