Part No 2001105
5
Invacare PreciseR
x
™ Pediatric Flowmeter
Set Up With A Humidifier Bottle If Prescribed
1.
Connect a 2.1 m (7 ft) max oxygen tubing from the output fitting of the concentrator to the input
fitting on the pediatric flowmeter.
2.
Follow the directions supplied by the humidifier bottle manufacturer for instructions on filling and
connecting to oxygen tubing.
3.
After filling the humidifier bottle with water, place it in the humidifier compartment on the Invacare
concentrator (see concentrator owner’s manual for mounting the bottle).
4.
Connect 2.1 m (7 ft) max oxygen tubing from the pediatric flowmeter output fitting to the inlet of
the humidifier bottle (using an appropriate adapter if applicable).
5.
Connect 7.6 m (25 ft) max oxygen tubing to the outlet of the humidifier bottle (not shown).
6.
Attach the opposite end of the oxygen tubing to a nasal cannula using an appropriate oxygen tubing
connector (not shown).
FIGURE 2
Typical Setup - Set Up With A Humidifier Bottle If Prescribed
For this procedure, refer to FIGURE 2.
CAUTION
DO NOT coil crush resistant oxygen tubing on COLD floor or condensation will form
inside the tubing.
2.1 m (7 ft) Oxygen
Tubing
Output Fitting
Concentrator
Pediatric
Flowmeter
Output Fitting
Input Fitting
2.1 m (7 ft) Oxygen Tubing
Inlet of
Humidifier Bottle
Humidifier
Bottle