NOTE
The indicator light in the ON/OFF switch may also begin to flash in certain other situations, because it also
functions as a fault indicator in the event of any failure in the electric and/or electronic system of the Powerchair.
For details, refer to the TROUBLESHOOTING in the joystick Operation Manual supplied with your Joystick..
Check the joystick rubber gaiter and keypad are in good condition and show no signs of cracks, pin holes, etc.
Once a month check the various connections on the underside of the power module to verify that they are in
place and tight. Damaged or corroded connectors or terminals, as well as damaged cables should be replaced
immediately.
IMPORTANT
All Cables of the control system have special-type connectors which fit into their respective sockets in the power
module. They are locked in place by a small spring pin on the side of the connector. To disconnect a cable, when
you want to remove the joystick box or fold the Powerchair for example, grasp the connector with your fingertips
and squeeze the spring blade or spring pin against the connector and at the same time pull the connector out of
its socket. To reconnect a cable, place the connector against its socket, check that you hold it in the correct
position relative to the socket, then simply push it firmly home into the socket until the spring blade or spring pin
snaps into lock. It is most important that these cable connectors are correctly installed at all times, otherwise the
Powerchair cannot operate properly. If you are in any doubt as to the proper functioning or condition of any part
of the control system, do not hesitate to contact your
INVACARE
supplier/dealer immediately.
DO NOT attempt to open the joystick box or the power module as this will invalidate all warranties.
Cleaning
Upholstery and metal work can be maintained by a wipe-over with a soft cloth. If you have been out in
wet, muddy conditions, sponge off all dirt and wipe with a dry cloth. Should chromium parts develop dull
areas during the course of time, especially if your Powerchair is frequently is exposed to high humidity,
rain etc., the finish can be restored with a proprietary brand auto wax or chromium polishing agent.
DO NOT use any harsh abrasives. As a preventive treatment against the loss of high polish chromium
parts may be given a light petroleum jelly coating. DO NOT use solvents, silicone spray, polishing wax or
any abrasive cleaning materials
BATTERIES AND BATTERY CHARGING
IMPORTANT WARNINGS
THE BATTERY CHARGER SUPPLIED WITH YOUR POWERCHAIR IS FOR INDOOR USE ONLY, IT
MUST BE PROTECTED FROM MOISTURE AND EXTERNAL HEAT SOURCES.
HANDLE THE BATTERY CHARGER WITH CARE, IF IT HAS BEEN DROPPED OR DAMAGED, DO
NOT USE IT.
DO NOT USE AN EXTENSION LEAD FOR CONNECTION FROM THE MAINS TO THE CHARGER
UNLESS ABSOLUTELY NECESSARY. IF YOU DO USE ONE ENSURE IT IS IN GOOD CONDITION.
ONLY USE THE CHARGER SUPPLIED WITH YOUR POWERCHAIR.
BATTERIES ARE HEAVY, IF YOU HAVE TO REMOVE THEM, ENSURE YOU ADOPT THE CORRECT
LIFTING POSTURE TO AVOID INJURY. ASK FOR ASSISTANCE IF NECESSARY.
13
