3
KEY FUNCTIONS
DESCRIPTION
Displays or selects a manufacturer as well as insert and flat number.
Displays or selects key code to be cut. Displays cutter angle where applicable.
Displays Maximum Space to be cut. Also shows tip type and whether key is paused
or not. If paused this key will put an l in the display to indicate a Left cut angle.
Displays Max and Min Depths. Note: there maybe invalid depths between the max
and min values that are invalid, as in Simca. If the table is paused this key will put an
R in the display to indicate a right cut angle.
Displays selected amount of depth correction, flat number, units, plunge mode and
cut feed rate.
Starts cutting operation. If the table is paused this resumes cutting after changing
angles or space position of cutter.
Corrects number entries and aborts functions.
Resets the machine, same as turning power on. Also aborts a cutting operation.
Entry keys for ID’S, Codes, Etc.
Used to enter 11th depth in code i.e. 0-10. (Displays as
A
)
Used to switch sign of C.F. and Calibration numbers, -5 is negative. Used also to
bypass a cut position in code. (Displays as X)
Alphabetical keys A-Z are arranged in pairs. The top red letters are accessed
directly. The bottom section of each key is accessed by pressing the Alt key first.
