10
SELECTING ID TO BE CREATED
Enter the EDIT mode by pressing the
keys.
To create ID 803, press
followed by
The ITL950C will display
EDITING ID
803.
You have now set the lD number to be edited.
Press
,
screen will display
ENABLE PAUSE (Y or N)
press
to toggle. Pause is
used with keys that require different cut angles as with
MEDECO(c),
safety deposit box keys and
other flat steel keys. When pause is enabled, the machine will stop the cutter after each cut.
SETTING TIP TYPE
Press
,
screen will display
TIP TYPE = 3.
The tip type in an ID determines which reference
point is used to cut a key. To enter the new tip type of 2 press
.
TABLE OF TIP REFERENCE POINTS
TIP REF #
OFFSET
RANGE OF SPACES
NOTES
0
0.000
INCHES
0.001-1.350
INCHES
SHOULDER REFERENCE
1
1.025
INCHES
0.000-0.749
INCHES SAFETY DEPOSIT KEYS
2
1.150
INCHES
0.000-1.149
INCHES USE INSERTS 1A, 1B, 1S.
3
1.350 INCHES
0.000-1.349
INCHES
REFERENCE FROM
RIGHT VISE EDGE
SELECTING A FLAT
Press
the lTL950C now displays
FLAT NUMBER —.
The flat determines how wide the bottom of each cut will be. Note: flat 1 produces the same
width as the cutter being used.
The flat ranges from 1 through 10. To select flat 4, press
,
followed by
.
The
display will now show
FLAT 4
. Refer to the table of flats on page 8.
SELECTING INSERT NUMBER
Press
the ITL950C will now show
INSERT —.
Refer to the following table for further
information on inserts. To select insert 3, press
followed by
.
The display will now show
INSERT 3.
Press
to continue. Clear may be used to correct entries or return to edit mode.
