www.inline-info.com
14
15
3. Control Options
19. NETWORK
Item
Option
Description
Show OSD
Tick to display each receiver’s number on all connected monitors.
Control options
Reset to basic setup
You may click to restore if confusing all the video wall settings below.
All the settings will restore to the settings on the Basic Setup.
Stretch type
Select a preferred display type.
Clockwise Rotate
Rotate the video depending on the requirement.
Screen layout
Set the layout of video wall. Make sure the layout settings here is
same as the Basic Setup tab.
Row position
Change the row position of the selected unit.
Column position
Change the column position of the selected unit.
Horizontal shift
Fine-tune the image position of horizontal to left or right. Note that the
screen will be displayed in loop horizontally if the position is adjusted
out of edge. It’s recommended to enlarge the image from the option of
Horizontal/Vertical scale up
first before shifting the position.
Vertical shift
Fine-tune the image position of vertical to up or down. Note that the
screen will be displayed in loop vertically if the position is adjusted
out of edge. It’s recommended to enlarge the image from the option of
Horizontal/Vertical scale up
first before shifting the position.
Horizontal scale up
Scale up the image from receiver horizontally.
Vertical scale up
Scale up the image from receiver vertically.
Console API command
Refer to the UAPI commands guide (optional available).
Item
Option
Description
IP setup
Auto IP
Assign an IP by system automatically. It’s an option of default
and recommended.
DHCP
Assign an IP by DHCP server automatically. A DHCP server
is necessary.
Static
Assign an IP manually. After pressing the Apply button, all the
settings will be saved even the power is disconnected
Casting mode
Multicast
Select this option if your extender network structure is mul-
ti-connection.
Unicast
Select this option if your extender network structure is point-
to-point connection.
Auto select USB operation
mode per casting mode
Tick this option if there is a USB connected. The connection
mode will be detected automatically.