PacMate
PAPER JAM:
If too much materials is fed to the cutting system
the cutting system will jam. Proceed as follows:
- Operate the rocker switch (1) (fig. 1) to position
„bowed arrow“.
- The cutting system runs in reverse and free up
excess materials.
- Remove excess materials from the machine and
continue processing with a smaller amount of
material.
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the machine off with
the rocker switch (1) (fig. 1) (position „0“). Allow
the motor to cool down for 15 to 20 minutes
(depending upon room temperature) and then
continue shredding.
CHECKLIST IN CASE OF MALFUNCTIONS:
If the device does not function, check the follo-
wing:
- is the
plug connected
to the mains?
- is the
rocker switch (1)
on?
- Is there a
material jam in the inlet chute
?
Follow the instructions under „MATERIAL JAM
IN THE INLET CHUTE“.
- has the
motor
been overloaded?
Wait until the motor has cooled, and then re-
start.
If none of the above applies, please contact
your dealer.
No structurel modifications may be
carried out!
In case of non-observance, the opera-
tion permission expires.
83381 10 01/14
TECHNICAL DATA
INSTALLATION
INSTALLATION INSTRUCTIONS:
Proceed as follows when installing and setting
up the machine:
1.
Place the machine on a table so that the two
feet at the back are lined up with the edge of
the table.
Do not worry: the machine‘s centre of gravity
is always located over the table and it cannot
tip over the edge.
2.
Pull the metal frame for the waste bag out as
far as possible (fig. 3)
3.
Hang the plastic bag into the frame and secure
it to the two hooks at the side of the housing.
Then fold the edge over the frame from the
inside out (fig. 4).
MALFUNCTION / MAINTENANCE
ACCESSORIES
Description
Order-No.
Plastic bag, 440 x 390 x 1100 x 0,03 mm
99951
Note:
For orders of special accessories and spare parts, please contact your dealer.
Cutting width:
3.8x112 mm
Cutting capacity:
1 layer corrugated
board quality 1.2
(max. thickness of
cor. boards 18 mm)
Inlet guide:
10 mm
Working width:
400 mm
Cutting speed:
0.13 m/sec.
Power consumption:
1.1 kW
Intermittent service:
30 min – 15 min
Supply voltage:
230V/50Hz
240V/50Hz
120V/60Hz
100V/50/60Hz
Pre-fusing:
230V:
16 A
240V:
13 A
100V-120V:
20 A
Width:
525 mm
Depht:
300 mm
Height:
375 mm
Noise level:
approx. 61 dB(A)
Weight:
approx. 38 kg
GB
DISPOSING OF THE MACHINE:
Dispose of the machine in an
environmentally sound fashion at the end
of its useful service life. Do not dispose of
any of the parts included in the machine
or its packaging with household trash.
DISPOSING
5
fig. 3
fig. 4
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
Summary of Contents for PacMate 344-41S
Page 34: ...PacMate 83381 10 01 14 34...
Page 35: ...PacMate 83381 10 01 14 35...
