95650 1 11/17
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
GB
10
4 .2 In case of a minor paper jam
In case of a minor paper jam the
overload LED
(Fig. 1/3) will light up
1 .
Grasp the excess paper from the top and pull it out
as you depress the REVERSE button (Fig. 1/8). Be
careful not to place your fingers near the feed ope-
ning or else serious harm could result.
2 .
Make sure that all of the excess paper has been re-
moved from the feed opening.
3 .
You are now ready to resume normal shredding.
4 .3 In case of a major paper jam
In case of a major paper jam the
overheat LED
(Fig. 1/2)
will light up.
1 .
Turn off or unplug the power cord from the AC
outlet and wait at least 40 minutes for the thermal
overload protection to reset.
2 .
Plug in the AC power cord and place the ready
switch into the ON position.
3 .
lf paper was left inside the feed opening prior to
the overload, press the REVERSE button (Fig. 1/8)
and grasp the excess paper from the top and pull
it out.
4 .
Clear any excess paper shreds from the feed ope-
ning. Be careful not to place your fingers near the
feed opening or serious harm could result.
5 .
You are now ready to resume normal shredding.
5 Maintenance / Disposal
5 .1 Lubricating the cutting mecha-
nism
Cross-cut cutting mechanisms should be oiled regular
after a certain operating time to maintain the cutting
performance.
This can be easily accomplished if you pour special
shredder oil (Order-No. see
„Accessories“, p. 10
) as
shown on a sheet of paper and feed it through the in-
let guide to the cutting mechanism (Fig. 2).
000180
Fig. 2 Lubricating the cutting mechanism
5 .2 Tip for energy saving
Please make sure that the shredder is switched off over
night (ready switch (Fig. 1/5) in OFF position).
Keep the shredder turned off or unplugged when not
in use for prolonged periods of time.
5 .3 Disposal of the machine
Always dispose of the machine at the end of its
service life in an environmentally responsible
way. Do not toss any part of the machine or its
packaging into the garbage.
6 Technical Data
intimus 29 CP4
Shred Type:
Cross-Cut
Shred Width:
4 x 39 mm
Shredding Capacity:
16 sheets (80g/m2)
Input:
220-240V, 50-60 Hz
Duty cycle:
30 min. ON / 40 min OFF
Feed Opening:
220 mm
Dimensions (WxDxH):
400 x 280 x 550 mm
Noise level:
55 dB(A)
Weight:
12,4 kg
7 Accessories
Designation
Order-No .
Oil bottle, 110 ml
88035
NOTE!
When reordering accessories and to purchase
spare parts, please contact your intimus ser-
vice partner.
Summary of Contents for 29 CP4
Page 19: ...95650 1 11 17 29 CP4 19 ...
