42
3. Remove the CVT cover.
4. Remove all debris wrapped in and around the CVT system and air duct
passage.
5. Check for signs of damage to seals on the transmission and engine. See
your dealer promptly for service if any seals appear to be damaged.
6. Replace the CVT cover and the seat.
CVT Drying
Use the following instructions to dry out a wet CVT before operating:
1. Ensure that the vehicle is safely parked on a flat surface with the engine off.
2. Remove the CVT drain bolt
3. Allow all water to drain from the CVT.
4. Reinstall the drain bolt.
Figure 28: CVT Drain Bolt Location
Note:
If any debris entered the CVT, the CVT must be cleaned and inspected.
5. Apply the brakes and start the engine.
6. Apply varying throttle for 15 seconds to expel the moisture and air-dry the
belt and clutches. Do not hold the throttle at maximum.
7. Allow the engine RPM to settle to idle speed.
8. Shift to “Low” gear.
9. Drive slowly. Test for belt slippage. If the belt slips, begin the drying process
from step 1.
10. If the belt continues to slip after repeating the process several times, take
the vehicle to your authorized dealer.
Summary of Contents for GC 1K
Page 1: ...2020 OWNER S MANUAL...