155
PO
SAVE THESE INSTRUCTIONS
Page 7
(155PO) POOL LIGHT ENGLISH 7.5” X 10.3” PANTONE 295U 11/21/2009
English
• Rearrange the orientation of the pool
light and the transmitter. See “setup
instructions”.
• Plug the cord firmly into the
electrical outlet.
• Tighten the intermediate
connection between the
transmitter and the transformer.
• Rearrange the orientation of the pool
light and the transmitter. See “setup
instructions”.
• Contact Intex Service Center.
• Contact Intex Service Center.
DIFFICULT TO
ALIGN THE POOL
LIGHT AND THE
TRANSMITTER
THE LED
POOL-WALL LIGHT
DOES NOT LIGHT
UP
THE POOL LIGHT
UNIT DOES NOT
FLOAT
• Wrong orientation, magnetic
poles are not aligned correctly.
• The power cord is loose.
• Wrong orientation and
alignment between the pool
light and the transmitter.
• Water inside pool light unit.
• Possible transmitter or
transformer failure.
• Water inside the pool light
unit.
PROBLEM CAUSE SOLUTION
TT
RR
OO
UU
BB
LLEE
SS
HH
OO
OO
TT
IINN
GG
GG
UU
IIDD
EE
IMPORTANT
If you continue to experience difficulty, please contact our Consumer
Service Department for assistance. See back cover for contact information.
TROUBLE SHOOTING GUIDE
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
