155
PO
SAVE THESE INSTRUCTIONS
Page 6
(155PO) POOL LIGHT ENGLISH 7.5” X 10.3” PANTONE 295U 11/21/2009
English
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
&&
SS
TT
OO
RR
AA
GG
EE
SETUP INSTRUCTIONS (continued)
3.
Adjust the position of the pool light by manually sliding the transmitter position
sideways and/or vertically.
4.
Plug the assembled unit to an electrical outlet protected by a ground-fault
circuit interrupter (GFCI).
Installation on Intex Sequoia Spirit Wood-Grain Pools:
Unscrew the bolts from the section where
the LED pool-wall light will be installed, and
remove the clamp covers, the top board and
the side boards. Refer to the Wood-Grain
Pool owner’s manual for details. For better
installation, it is recommended to remove at
least 3 side board panels. Follow above
setup instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice
damage to the product. It is recommended to remove, clean and store the
product in a safe place when temperature drops below 0 degrees Celsius (32
degrees Fahrenheit).
1
. Unplug the power cord from the electrical socket.
2.
Remove the transmitter
(2)
from the outside of the pool wall first, the pool
light
(1)
unit will automatically float to the surface for easy retrieval, then remove
the pool light from the water.
IMPORTANT: To prevent damage to the transmitter, always remove the
transmitter first before removing the pool light unit.
3
. If deposits or debris are seen inside the holes of the pool light, use a garden
hose to flush them off. Do not scrape the pool-wall light or use brush to clean it.
4.
Thoroughly air-dry all components before storage.
5.
Store the product and accessories in a dry, temperature controlled location
between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees
Fahrenheit (40 degrees Celsius).
6
. The original packaging can be used for storage.
4
