intexinternational.com
Copyright © 2020 Intex International.
Building Excellence
Site Equipment
Dual 500 Watt
Halogen
Work Light
SHL20
ASSEMBLY INSTRUCTIONS
2 x 500 Watt (150 Watt) (TWIN HEAD)
1. Unpack fixture and place all parts on a smooth surface.
2. Mount each of the 2 fixtures to the cross bar in Fig. 1.
a. Put the washer between the U bracket of the fixture and the bar to allow the fixture to turn without
scratching the bar as shown in Fig. 1.
b. Be sure not to over-tighten the adjusting knob.
c. Both fixtures can be mounted in the same manner.
3. Mount the fixture assembly bar to the top of the telescope pole by butting one washer on the top of
the bar then tighten the centre knob as shown in Fig. 2. Be sure not to over-tighten the centre knob.
4. The tripod legs are adjustable to up or down position by loosening the knob as shown in Fig. 3. Do not
adjust the legs by force because they should move easily to desired position.
5. Adjust the telescope pole to desired height by loosening and tightening lock nuts located at the top of
each extension as shown in Fig. 4.
6. The fixture is now ready for use.
1 x 500 Watt (150 Watt) (SINGLE HEAD)
Follow the same instructions as 2 X 500W except that point 2 & 3 change to as following:
Mount the fixture assembly to the top of the telescope pole by turning centre knob clockwise until
secure as shown in Fig. 5. Do not over-tighten the centre knob.
***WARNING***
1. This fixture is GS listed and safe when used in a careful manner.
2. Fixture heads get very hot and should not be used within 18” of combustible materials such as paper,
cardboard, wood or fabric to avoid starting a fire.
3. Do not use this fixture near combustible materials such as gasoline to avoid explosion. Always
unplug the fixture before doing any work or when changing the bulb.
4. In event that you need to move the fixture to the next job site or change a bulb, ample time should be
given to cool as fixture head gets very hot.
5. Never point the fixture directly at a person’s eyes.
6. Do not touch the halogen bulb when installing it in the fixture as oil from your skin will shorten the
bulb life significantly. Best to use a clean cloth to install the bulb.
7. Never touch the fixture when power is on because surface is hot and can cause severe burns.
***BULB INSTALLATION***
1. Use max. 500W T-3 halogen bulb.
2. Disconnect power and allow bulb to cool prior to installation.
3. Use screwdriver to release the frame and remove old bulb. Push gently toward the right side of the
socket until left side is clear from socket and can be removed by moving forward.
4. To install bulb, only use clean gloves or cloth. Fit the bulb into side goes into its socket, allow left end
to be inserted into left hand side of socket.
5. Never turn power on with hinge door open.
FIG 1
FIG 2
FIG 3
FIG 4
FIG 5
