(19PO) AP619D ELECTRIC PUMP ENGLISH 4.875” X 7.25” 04/30/2020
19PO
READ AND SAVE THESE INSTRUCTIONS
Page 4
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel.
Do not
expose the airbed to extreme temperatures (hot
or cold).
Stretching is a natural characteristic of new vinyl. During initial use, the airbed may become
soft and require additional inflation to maintain desired firmness. This is normal for the first
few days of use.
Dimensions shown are approximate and will vary due to the vinyl temperature and the air
temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
4. When all the air is removed from the airbed, turn the valve control dial back (clockwise)
to the center position closing the valve. Then turn off the pump by pressing “O” on the
switch.
See Fig
(5)
.
5. With the airbed fully deflated begin rolling the airbed from the end opposite of the pump
towards the end where the pump is located. See Fig
(7)
.
6. Disconnect the AC line cord from the electrical outlet, coil the line cord and place it
inside the cord compartment, then close the cover. Make sure the line cord is free
of twists, kinks or knots.
FIg (7)
DEFlATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig
(2)
.
2. Switch ON the pump by pressing “I” on the switch located on top of pump. See Fig
(3)
.
3. Turn valve control dial fully counterclockwise until it stops. The airbed is now deflating.
See Fig
(6)
.
MANUAl INFlATION OPTION
If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the line cord
compartment. See Fig
(8)
. Follow these steps:
FIg (6)
Deflate
Position
