192
PO
S AVE THESE INSTRUCTIONS
(192PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 04/18/2013
English
Page 11
OPERATION
SPA CONTROL UNIT PANEL
Heat Button:
Use this button to activate the heating system. The pump will heat the spa water
until the water temperature reaches the set temperature. After the current water temperature
drops 2°C (3.6°F) below the set temperature the heating system will restart. When the light
above the heat button is red, the heating system is activated. When the light is green, the water
is at the set temperature and the heating system is at rest.
NOTE:
If the heating system is activated the fi ltration system will automatically start.
NOTE:
After turning off the heating system the fi ltration system will continue to operate 24 hours.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is
Celsius.
CAUTION:
NEVER use the spa if indicated water temperature is more than 104ºF (40°C).
Temperature Adjustment Buttons:
Pressing the Temperature Increase or Decrease
buttons will cause the LED to fl ash. When fl ashing you can adjust to the desired temperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to confi rm the new
value.
NOTE:
The default temperature is 68°F (20°C).
NOTE:
Temperature adjustment ranges from 68°F (20°C) to 104°F (40°C).
Reset
Button:
Pressing the Reset button when Code “E95” a
ppears on the LED display
control
panel.
Water Filter Button:
This button turns the fi lter pump on and off.
The light above the Water Filter Button displays green when activated.
Bubble Button:
Use this button to activate the massage system, which has a 30-minute
auto-shutoff feature. The light above the Bubble Button displays green when activated.
WARNING:
Do not run Bubble system when the cover is attached, air can accumulate
inside the spa and cause irreparable damage and bodily harm.
LED Display:
Once powered-up the LED displays the current water temperature automatically.
A: Heat Button
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
D: Temperature Decrease Button
E: Reset Button
F: Water Filter Button
G: Bubble Button
H: LED Display
˚
C
˚
F
RESET
104
F
o
G
F
D
C
E
B
A
H
RESET
˚
C
˚
F
IMPORTANT:
The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5. 4m/s).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
F
104
o