250
PO
S AVE THESE INSTRUCTIONS
(250PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 01/10/2014
English
Page 13
LED CODE CHART
E90
No water fl ow
•
Ensure the unit is plugged and switch on.
•
Ensure the outlet cover grid is clean and free
from obstructions.
•
Clean or replace the cartridge, see
Maintenance and Storage section.
•
Ensure the in/outlet connections on the spa tub
and fi lter pump are not blocked.
•
Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
•
If problem persists, contact Intex Service
Center.
E94
Water temperature too low
•
If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
•
Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
•
Press the temperature increase button to set
the desired water temperature.
•
If problem persists, contact Intex Service
Center.
E95
Water temperature too high
•
Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
•
Press the temperature decrease button to
lower the water temperature.
•
If problem persists, contact Intex Service
Center.
E96
System Error
•
Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
•
If problem persists, contact Intex Service
Center.
END
After 72 hours of operation,
the pump will hibernate and
the rapid heating and water
fi ltration functions are disabled.
•
Press the water fi lter button to re-active the
fi lter pump.
LED Reading CAUSE SOLUTION
