346
PO
S AVE THESE INSTRUCTIONS
(346PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/10/2019
English
Page 14
SPA CONTROL PANEL
F: Heat Button
G: Celsius/Fahrenheit Toggle Button
H: Heat System Delay Timer (HSDT) Button
I: Heat System Operating Hours (HSOH) Button
OPERATION (continued)
Heat Button:
Press this button to activate the heating system. Press or to set the desired
water temperature. The system will heat the spa water until the water temperature reaches the
set temperature. When the spa water temperature drops 2°F below the set temperature the
heating system will restart. When the
fl
ame icon on the display is red, the heating system is
activated. When the
fl
ame icon turns green, the water is at the set temperature. The heating
system is at rest and the
fi
ltration system will continue working nonstop. If the heating system is
activated the
fi
lter pump will start at the same time.
NOTE:
To stop the
fi
ltration system while the heater is at rest mode, press the
fl
ame button
fi
rst and then the
fi
lter button. Pressing the heat button only while the heater is at rest mode will
turn off the heating system only and the
fi
ltration system will operate for 1 more minute before it
turns off or continue with the
fi
lter pump preset operating hours.
IMPORTANT:
The following conditions will lead to slow water heating.
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 3.5-5.4 m/s (8-12 mph).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or
Celsius. The system’s default is Celsius.
NOTE:
The default temperature is 68°F (20°C). Temperature adjustment ranges from 50°F
(10°C ) to 104°F(40°C).
CAUTION:
NEVER use the spa if indicated water temperature is more than 104ºF(40°C).
Heat System Delay Timer (HSDT) Button:
Press this button and then press or to set
the heating system starting time timer, from 001 to 120 hours. The icon will
fl
ash red for a few
seconds and then stays red. Once the countdown timer reached 000, the heating system will
start operating. Repeat previous steps to reprogram this function. Set the Heat System Delay
Timer time to 000 to deactivate this function. Press the HSDT button twice any time to re-adjust
the preset hours.
Heat System Operating Hours (HSOH) Button:
Press this button and then press or to
set the heating system operating hours from 000 to 048 hours. The icon will
fl
ash red for a few
seconds and then stays red. The heating system will operate for the amount of preset hours
only regardless if the preset spa water temperature is reached or not. The information shown on
the LED display alternates between the remaining operating hours and the water temperature,
provided the HSDT function is not set. Repeat previous steps to reprogram this function. Set
the Heat System Operating Hours to 000 to deactivate this function. Press the HSOH button
twice any time to re-adjust the preset hours.
H
G
F
I
