(178) MODEL SF10110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2012
178
SAVE THESE INSTRUCTIONS
Page 12
English
4.
In a clockwise motion screw filter housing nut
(17)
onto the motor water inlet
(See drawings 12.1 & 12.2)
.
5.
Replace the basket
(16)
and leaf trap cover
(14)
back to the pre-filter housing
(See drawings 13.1 & 13.2)
.
SETUP INSTRUCTIONS (continued)
SETUP
INSTRUCTIONS
Sand tank installation:
1.
Place the tank support base on the selected location.
2.
Place the tank on the tank support base
(See drawing 14.1).
3.
Connect the motor pre-filtering assembly unit to the tank support base
(See
drawing 14.2)
. NOTE: Ensure the pre-filter housing water inlet hose connection
is facing towards the pool.
IMPORTANT: Some countries, especially in the European community,
require the product to be secured to the ground or to a base in a
permanent upright position. Check your local authorities to determine if
there is a regulation in your area regarding above-the-ground swimming
pool filter-pumps. If yes, then the product can be mounted to a platform
using the two holes located in the base. See drawing 14.3.
The product can be mounted on a cement base or onto a wooden
plat form to prevent accidental falling over.
• The mounting holes are 6.4 mm in diameter and spaced 160 mm
apart.
• Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
12.2
12.1
13.1
13.2
14.1
14.2
m
m
160
14.3
17
17
14
16
35
