(112PO) 619SP SMART BUILT IN PUMP ENGLISH 4.875” X 7.25” 09/07/2018
112
PO
READ AND SAVE THESE INSTRUCTIONS
Page 5
DEFLATION
1. Attach the AC line cord to the pump cord connector and plug into an AC electrical
outlet.
See Fig (2 & 3)
.
2. Press the deflation button ( ) to deflate.
See Fig (10)
.
3. When the airbed is almost deflated, begin rolling the airbed from the foot of the airbed
towards the head of the airbed where the pump is located.
See Fig (11)
.
Press
“ ” to switch OFF when the airbed is completely deflated.
See Fig (10)
.
Note:
The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended. If there is still some air inside, repeat step
#2 thru #3 as necessary.
4. Disconnect the AC line cord from the pump and the electrical outlet, place it inside the
cord compartment and close the cover. Make sure the power cords are free of twist,
kink and knot.
DEFLATION OPTION
1. If electrical power is not available then open line cord compartment cover, unscrew
the exhaust valve cap to release the air.
See Fig (12)
. Begin rolling the airbed from the
foot of the airbed towards the head of the airbed where the pump is located to remove
all the air. Close the exhaust valve cap back.
Inflate only with a low pressure inflator. Do not over inflate. Fill with cold air only.
IMPORTANT
FIG (11)
FIG (10)
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel.
Do not
expose the airbed to extreme temperatures (hot
or cold). Stretching is a natural characteristic of new vinyl. During initial use, the airbed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
FIG (12)
