(112PO) 619SP SMART BUILT IN PUMP ENGLISH 4.875” X 7.25” 09/07/2018
112
PO
READ AND SAVE THESE INSTRUCTIONS
Page 3
INFLATION
1. Unfold the airbed. Open line cord compartment cover.
See Fig (1)
.
2. Attach the AC line cord to the pump cord connector and plug into an AC electrical outlet.
See Fig (2 & 3)
.
3. Press the inflation button ( ) to inflate.
See Fig (4)
. The inflation indicator will light up
during the inflation.
4. When the airbed is inflated to the desired firmness, press “ ” again to switch OFF.
Note:
The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended or when airbed is fully inflated.
INFLATION OPTION
1. If electrical power is not available then a conventional foot or manually operated air
pump can be connected to the 2-in-1 valve for inflation.
2. Pull the 2-in-1 inflation valve cap out, insert air pump nozzle into the valve to inflate the
airbed.
See Fig (5)
.
ADJUST THE FIRMNESS USING THE PRESET FIRMNESS BUTTONS
Lie down on the airbed to test and adjust the firmness.
1. Adjust the airbed firmness by pressing one of the following preset firmness buttons:
SOFT (
), MEDIUM (
) or FIRM (
).
See Fig (6)
.
2. The indicator light stays on when the airbed is being inflated to the selected preset
firmness. Once the firmness is reached, the pump will stop inflating.
Note:
Whenever the airbed pressure drops below the selected preset firmness, the
pump will automatically add air until it reaches the selected preset firmness. The pump
must be connected to an electrical outlet at all time.
FIG (1)
√
110 – 120 V
220 – 240 V
FIG (3)
FIG (4)
FIG (2)
FIG (5)
FIG (6)
