(130PO) MINI SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/31/2021
130
PO
SAVE THESE INSTRUCTIONS
English
Page 16
TROUBLESHOOTING GUIDE (continued)
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.
1.
Filter pump not attached to
system and/or switch on.
2
. Circulation line is blocked.
3
. Incorrect inlet and outlet hose direction.
4
. Scale on flow sensor pins inside the
titanium electrode.
5
. Electrode cord is loose.
6
. Inner timer conflict between
filter pump and saltwater system.
1
. Dirt or scale on titanium plates.
2
. Low salt level / No salt.
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
1
. High salt level.
2.
Water temperature > 35ºC.
3.
Titanium electrode failure.
•
Ensure a filter pump with the correct flow
rate is attached and operating. See "Setup
Instruction".
•
Remove the black hat-like plugs from the pool
strainer connectors.
•
Clear your filter cartridge and cell from debris
and dirt. See “Maintenance”.
•
Release all trapped air in the circulation line.
See the filter pump manual.
•
Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See “Set
Up Instructions”.
•
Clean the titanium electrode. See
“Maintenance” section.
•
Plug the cord into the electrode and tighten the
plug collar firmly.
•
Reset both timers on the filter pump and
saltwater system. See “Operating Instructions”.
•
Remove the electrolytic cell for inspection.
Clean it if necessary. See “Maintenance”.
•
Add salt. See “Salt & Pool Water Volumes”.
•
Ensure that the cell cord is plugged firmly into
the cell housing receptacle.
•
Contact Intex Service Center. Replace the cell
if needed.
•
Partially drain the pool and refill it with fresh
water. See “Salt & Pool Water Volumes”.
•
Contact Intex Service Center.
•
Contact Intex Service Center.
LED PANEL
CODE
PROBLEM
SOLUTION
LED Panel Code Flash & Alarm On (
NOTE
: Always turn off the power before cleaning and servicing).
