TROUBLESHOOTING GUIDE
PROBLEM
CAUSE
REMEDY
INSUFFICIENT
SANITIZER
z
Insufficient operating
hours of the saltwater
system.
z
Insufficient salt
concentration in the
saltwater tank.
z
Sanitizer loss due to
intense sunlight
exposure.
z
The bather load has
increased.
z
Increase the saltwater system
operating time per day. See
“operating Instructions”
z
Drain out all the water in the
saltwater tank. Refill water and
add salt in the saltwater tank.
See “How to Add Salt” or
“Removing Salt".
z
Use Pool Cover when the pool
is not use and/or when the unit
is operating.
z
Increase the saltwater system
operating time per day. See
“operating Instructions"
WHITE FLAKES IN
THE WATER
z
Excessive calcium
hardness is present in
pool water.
z
Drain about 20 to 25% of the
pool water and add fresh water
to decrease the calcium
hardness.
WHITE FLAKES IN
THE WATER
z
Forgot to install baffle
adaptor. Filter cartridge
dirty.
z
Heater or the other
accessories are in use
simultaneously.
z
If the pool height is 107 cm
(42") and above, read manual
instruction and install the
suitable size of baffle adaptor.
z
Clean or replace the cartridge.
z
Disassemble the heater and
accessories within the
circulation line.
SALT WATER LEVEL
INSIDE THE
SALTWATER TANK
DROP TOO FAST.
z
Pool water level is too
low.
z
Fill the pool with more water.
z
Remove the baffle adapter B
from the saltwater system
outlet (if any).
IMPORTANT
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department
for assistance. See back cover for contact information.
SAVE THESE INSTRUCTIONS
Page 24/ 29
