SAVE THESE INSTRUCTIONS Page 11
For connection to filter pumps with 38mm (1-1/2”) hose size:
Do not use adapter A
(15)
1.
If your above-ground-pool is filled with water, close the plunger valves
before saltwater system installation. Go to step 2 directly if your pool is
empty.
2.
If your above ground pool is equal or
higher than 107cm (42") in height,
insert the water baffle adaptor A
(14)
into the saltwater system outlet as
shown in Fig. 5. Go to step 3 directly
if your pool is lower than 107cm (42")
in height.
3.
Disconnect the water return (to the
pool) hose from the filter pump
connection, and connect it to the
saltwater system outlet. See Fig. 7.
NOTE:
Make sure the LED lights on the saltwater system are facing out
from the pool during the installation as shown in Fig. 7.
4
. Connect connector hose
(18)
to the filter pump outlet (lower connection)
and saltwater system inlet. Tighten securely. See Fig. 7.
5.
Open plunger valves to allow water to flow.
Fig (7)
SWIMMING POOL
FILTER
PUMP
Fig (5)
NOTE:
Remove the strainer at the pool inlet to allow the maximum flow rate of the
water to the pool.
SAVE THESE INSTRUCTIONS
Page 11/ 29
