8
Interwrite
TM
Pad
Getting Started
Charging the Interwrite Pad and
Interactive Pen
Before you use your Interwrite Pad and Interactive Pen for the first time, they
should be charged for about three hours, or until the
Pad Battery Status Light
goes off. Whenever the Pad battery is low and needs to be recharged, the Pad
Battery Status Light will flash slowly.
1
Place the Interactive Pen in the
Pen Tray
with the
Rocker Button
and
Tether Loop
facing up.
2
Connect the Pad Charger’s cable to the
Charger Power Jack
at the top of
the Pad.
3
Plug the Charger into an AC power outlet.
The Interwrite Pad can be used while it is charging.
4
When the Pad and Pen are charged and the
Pad Battery Status Light
goes
out, unplug the Charger from the Interwrite Pad.
5
Turn on the
Power Switch
when the Interwrite Pad is charged.
The buttons and status lights are described in more detail in the
Operating the
Interwrite Pad
section beginning on page 20.
Attaching the Tether to the Pad and the Pen
The tether has a loop at each end. One end has a metal ring attached to the
loop – that’s the Pen loop. The other end is the Pad loop.
1
Thread the Pad loop up through the hole above the Pen Tray. Thread the
Pen loop through the Pad loop. Pull to tighten.
2
Thread the metal ring through the Tether Loop eyelet on the Pen.
The first thing you should do when you unpack your
new Interwrite Pad and Interactive Pen is charge them.
The Pen can be charged only when it is placed in the Pen Tray on the
Pad, and only when the Pad is being charged. A Pen charge lasts over 40
hours. You should always charge the Pen when the Pad is being charged.
