HOW TO OPERATE YOUR VACUUM CLEANER
InterVac Design Corporation Palm City, Florida, 34990
toll free 1-888-499-1925
e-mail: sales@intervacdesign. com
•
Website: www.intervacdesign.com
MODELS: F120 + H120 + CM120
NOTE: THE LOWER PART OF THE VACUUM CLEANER WILL BE QUITE WARM WHEN IN USE.
.
IF THE VACUUM STOPS RUNNING:
THE THERMAL PROTECTOR ON THE MOTOR WILL RESET AUTOMATICALLY AFTER
ABOUT 1-1/2 HOUR.
Replacement bag # Y05 high filtration or with our Hepa allergy filtration bag # YH1
PLEASE
SEE TROUBLE SHOOTING GUIDE.
A. Connecting and disconnecting the hose
B. On / Off Switch
C: How to change the dust bag,
C: To change motor filter, Replacement Part # Y21
1. Lift the inlet valve cover on the front of the door.
2. Insert hose cuff with a
to secure.
3. To remove, turn hose in either direction while pulling hose towards you.
1. To start the vacuum cleaner, push the switch to the “I” position.
2. To stop the vacuum cleaner, push the switch to the “O” position.
1. Remove door and dust bag.
2. Reach into the cavity towards the bottom of the vacuum cleaner and remove the motor filter.
3. Replace the filter with a new filter and tuck in the corners so that the filter lays flat on the grid,
with the printed words "
facing upward.
4. If necessary, clean the dirty filter by vacuuming or washing in mild soap by hand.
. Let filter dry completely and reuse as needed.
slight twist
1. Open the door on the vacuum cleaner by pushing the latch upward and remove both door and dust bag.
2. Carry door and dust bag to the trash container. Remove full bag and discard.
3. Place a new dust bag all the way over the scoop on the door.
4. When closing door, tuck in the left and right corners of the bag, so the door is properly sealed and the latch
clicks into place.
:
If you break off the vacuum hose inlet cover, simply reattach it by lining up one of the small dimples located on
the inside of the inlet cover and than press hard on the other side to click into position.
(see Fig.: E)
TIP
THIS SIDE UP!"
Do not clean in washing machine
5
Summary of Contents for CM-120
Page 8: ...10...