3
3
3
4
2
1
5
ATTACHING VACPORT TO AN EXISTING
REMOTE INSTALLED VACUUM
#1 Elbow fitting, does not need to be installed. Used only in tight spaces.
#2 Existing 2” diameter Flex-Hose or Vacuum Pipe. If you have
vacuum pipe installed , run the pipe straight into the “T” (#4)
#3 Black Threaded Coupling, 4 supplied. This coupling is screwed counter clock-
wise into the 2” Flex-Hose, the other end attaches to a pipe fitting with a twist
and push. Do not glue!
#4 45 degree “T” fitting, to attach to the existing hose or pipe.
#5 Pipe coupling, to be glued to the VacPort. On the other end either glue in the
elbow #1 and press-fit the threaded coupling.If elbow is not used just press-fit
a threaded coupling #3 into the pipe coupling #5.
4
Connect the LOW voltage
wire under screw heads.
NOT under Big Washer !
The door is held open by
2 small magnets.
Screw hole to attach VacPort to wall
VacPort Model A910
Without LEDs
Wall Opening location Pin
1)Remove old dust pan from the wall.
2)Use the same 2 screws and attach Trim Plate,
use the holes "A" from the removed VacPan
use the holes "B" from the removed the
VacuSweep
3)Mark the inside of the Trim Plate with a pencil.
4)Remove Trim Plate from the wall and cut the
opening larger along the pencil line.
5)Reattach the Trim Plate to the wall.
6)See page 3 how to attach the 24 volt wires
and Flex-Hose.
7)Now slide the VacPort into the new opening
and secure with the 2 #8 flat head tapping
screws and attach to the Trim Plate through
the "C" holes.
A
C
B
Replacing the 'VacPan' or 'Vacu-Sweep' with a VacPort installation
