QN HD CCU Instruction & Admin Manual
Page 37 of 32
InterT
est, Inc. • 303 Route 94 • Columbia, NJ 07832
+1 (908) 496-
8008 •
Released 7-16-20 Admin Version
Lens Correction
Line
Text
Control ID
Notes
Default FirstVersion
0
** Intertest QN HD **
0
1
Lens Correction
0
2
Lens Type
N/A
TBD
0
0
3
Color Temp
N/A
2800, 4500, 6500K options
(0,1,2)
0
0
4
5
6
7
Return to Utility
0
Bold-Italics means item is a submenu
Control ID provided for commands that go to the ISP
SCB300B Firmware Upload Procedure
The SCB300B board allows for both the old and new SerDes to be used and automatically detected
when plugged in to the RJ45 jack. In order to do this we must program both the versions of the ISP
(EM37180) code into the correct SPI Flash for the system to work properly. In order to make this easy
there is a new firmware programming mode that has been added to the PIC firmware (v1.02+) that is
accessed via the DIP switches on the SCB300B board.
To use the Firmware programming mode:
•
1. Set DIP8 to the OFF position o Normally DIP8 will be in the ON position to run the camera
(Pv1.02+)
•
•
2. Set DIP7 to OFF for the Old 914 SerDes or to ON for the New 954 SerDes
•
3. Then power on the board using a PC
•
4. The LCD screen should show either 914 or 954 depending on what was set on DIP7
•
5. If it shows a regular main menu then DIP8 is in the ON position. Turn it off and cycle power.
•
6. Start the EM_Download_Tool software o The tool should say “USB Init OK” at the top
•
o Select “Browse” and navigate to the supplied *914*.bin or *954*.bin file depending on which
you are trying to program
•
o Select “Download” and within ~10 seconds the download should be successfully completed
•
•
7. If you want to program the other SerDes then flip DIP7 and power cycle the board, following
from step 3 onwards.
•
8. Once you have programmed both Flash chips set DIP8 to the ON position to enter RUN
mode next time you power cycle the board.
