INTERSPIRO Spirotest 100, User Manual

Page: 9 / 24

Spirotest 100 Model 2016
9
2. Preparation
Before using the Spirotest 100 Model 2016 for testing it must be prepared and function
tested, with a Low pressure leakage test and a High pressure leakage test.
2.1 Low pressure leakage test
1. Connect the power cord with plug to a power supply.
2. Connect Sealing cap RD 40 (A) on to the Test connection (3).
3. Create a positive pressure of 10 mbar on the Low pressure gauge (2) by pressing the
Vacuum pump button (10) and the Positive pressure button (13) at the same time.
4. Check that the pressure remains constant for 1 minute, on the Low pressure gauge
(2).
5. Create a negative pressure of -10 mbar on the Low pressure gauge (2) by pressing
the Vacuum pump button (10) and the Negative pressure button (14) at the same
time.
6. Check that the pressure remains constant for 1 minute, on the Low pressure gauge
(2).
7. Disconnect Sealing cap RD 40 (A) from the Test connection (3).
8. Adjust the Low pressure gauge (2) to zero if necessary.
9. Low pressure test complete.
2.2 High pressure leakage test
1. Connect HP Adapter 300 bar (B) or HP Adapter 200 bar (C) to the SCBA set cylinder
valve (or other air source).
2. Connect Protective Plug Assy (D) to the HP Adapter.
3. Connect the hose from the HP Adapter to the High pressure connection (6).
4. Check that the Relief valve (5) is closed.
5. Check that Selector (7) is in the “Apparatus” position.
6. Slowly open the cylinder valve.
7. After 30 seconds close the cylinder valve.
8. Check that the pressure remains constant for 1 minute, on the High pressure gauge
(1).
9. Open the Relief valve (5) to release remaining pressure.
10. High pressure leakage test complete.
11. Disconnect the HP Adapter hose from the from High pressure connection (6).
12. Disconnect the Protective Plug Assy (D) from the HP adapter.
13. Disconnect the HP Adapter from the SCBA set cylinder valve (or other air source).
14. Close the Relief valve (5).