User Guide 083
UG083.0
July 25, 2016
Submit Document Feedback
3
What Is Inside
The evaluation kit contains:
• ISL76534EVAL1Z board
• The
ISL76534
datasheet
• This ISL76534EVAL1Z user guide
• ISLUSBMINIZEVAL1Z (USB to I
2
C module)
What Is Needed
The following instruments will be needed to perform testing:
• Power supplies:
- PS1: DC 20V/5A, (between A
VDD
and A
VDD
_AMP and GND)
- PS2: DC 20V/5A, (between D
VDD
and GND)
• Multimeters
• Oscilloscope
• Cables and wires
Initial Set-Up
This user guide describes how to set up and use the
ISL76534EVAL1Z evaluation board along with the
ISLUSBMINIZEVAL1Z in a standalone configuration. It explains
how to install the software and how to use the Windows interface
to read and write to the ISL76534 data register and EEPROM.
Evaluation Software
The next section explains how to install the Graphical User
Interface (GUI) software, which is used to configure the ISL76534
data registers and EEPROM.
Notes
The GUI software was developed on a 64-bit Windows 8 platform.
Because the GUI software registers as a Human Interface Device
(HID) and uses standard HID calls, it should also work on other
XP or later Windows operating systems (32-bit and 64-bit),
including Windows 7.
This user guide contains screenshots of the GUI at the time this
user guide was written. Subsequent GUI versions may appear
differently.
FIGURE 4. EXTERNAL CONNECTIONS AND JUMPERS
USB FROM
PC/LAPTOP
PLUG IN USB
MODULE TO
POWER
SUPPLY 1
POWER
SUPPLY 2
DIGITAL
MULTIMETER (V)
OSCILLOSCOPE
TO TIME
TO VBAT
BOARD
