InterSense InertiaCam IS-1500, User Manual, Page: 49 / 59

IS-1500 User Guide
Thales Visionix, Inc. MNL- 0024 (D) Page 49 of 59
B. To allow the system to run sfHub on a host computer and sfStudio or the end user application on a master computer, use the
following steps. NOTE: Image transfer to sfStudio or the user application is not supported in this configuration.
1. If they are currently running, close the sfHub and sfStudio or the end user application.
2. On the master computer, open the applicable sfAccess.ini file (for either sfStudio or the end user application).
3. Under the Processing section, find the TcpSfRxAddr variable. By default, the value is localhost (IP address 127.0.0.1).
[Communication]
TcpSfRxEnabled = true
TcpSfRxAddr = localhost
TcpSfRxPort = 51717
UdpSfRxPort = 9001
UdpSfRxImgPort = 9003
UdpSfCorePort = 9002
UdpSfRxInputPort = 9004
UdpSfHubPort = 9005
UdpNftPort = 9007
4. Change the value to the IP address of the host computer. In the example, the computer running sfHub has the IP address
192.168.1.101.
[Communication]
TcpSfRxEnabled = true
TcpSfRxAddr = 192.168.1.101
TcpSfRxPort = 51717
5.
Once the changes have been made, save the file.
6. On the host computer, open the sfHub.info file from the sfHub subfolder of the IS-1500 software directory.
7. Under the Master subsection of the General section, find the udpMeta, udpCore, udpNFT, and udpImg variables.
; TCP port for communication with sfAccess.
tcpPort 51717
udpMeta localhost :9001 ; Meta packet broadcast address
udpCore localhost :9002 ; Core packet broadcast address
udpNft localhost :9007 ; NFT broadcast address (IS-1500 only)
udpImg localhost :9003 ; Image packet broadcast address (IS-1200 only)
8. Change the address values for tcpPort, udpMeta, udpCore, udpNFT, and udpImg to match the IP address of the master
computer. In the example, the computer running sfStudio or the end user application is 192.168.1.100
; TCP port for communication with sfAccess.
tcpPort 51717
udpMeta 192.168.1.100 :9001 ; Meta packet broadcast address
udpCore 192.168.1.100 :9002 ; Core packet broadcast address
udpNft 192.168.1.100 :9007 ; NFT broadcast address (IS-1500 only)
udpImg 192.168.1.100 :9003 ; Image packet broadcast address (IS-1200 only)
9.
Once the changes have been made, save the file.