Interroll Transfer module SH 1400
18
Version 1.0 (06/2022) en
Translation of original operating instructions
Installation
WARNING
Risk of injury due to improper assembly
4
Mechanical assembly tasks should be performed only by service personnel. Observe the
safety information.
4
Electrical assembly tasks should be performed only by authorized electricians. Observe the
safety information.
4
Carefully install all terminals and connections, such as cables, hoses and pipework, and
check for correct fit.
The module is delivered to the installation site as a pre-assembled unit and must be set up,
connected and integrated into a system on site.
If available, photo cell and reflector are already pre-assembled and connected. The side guides
(universal support, side guide brackets and side guides) are also delivered assembled.
The installation tasks are divided into two sections:
• Setting up the module
• Integrating the module into a complete system
To be observed during installation
Electrical installation
DANGER
Danger - energized cable ends!
4
Electrical installation should only be performed by qualified electricians.
4
Ensure that the device is powered down.
4
Minimum bending radii of cables, hoses and lines must be maintained.
WARNING
Risk of injury from crushing and electrocution
Installation and maintenance tasks on a conveyor system while it is in operation can cause
crushing and electric shock.
4
Power down the entire conveyor module and ensure that it cannot be started accidentally.
The module is provided with voltage either via CEE plug or direct installation in the control
cabinet.
4
Check cables and components for damage before installation.
