22
Version 3.0 (04/2013) en
Translation of the original instructions
RollerDrive BT100
Maintenance and cleaning
Warnings concerning maintenance and cleaning
Maintenance
Checking the RollerDrive
If the RollerDrive is not secured as specified in the installation instructions (
see
"Assembly", page 15
), it may rotate in the hole in the conveyor frame. This
causes the RollerDrive to also rotate, and it can be damaged.
Monthly check the RollerDrive for visible damage.
Annually ensure that the roller shaft is secured properly in the conveyor
frame.
Replacing a RollerDrive
If a RollerDrive is damaged or broken down, must be replaced.
Install a new RollerDrive (
see "Abandonment", page 24
and
see "RollerDrive
Installation", page 17
).
Cleaning
Increased surface friction reduces the roller speed since more power is used to
overcome the resistance. Therefore, in a dirty environment, periodic cleaning will
ensure good contact with the goods and reduce friction.
Remove foreign materials and dirt with a simple cleaning brush (not a wire
brush) by brushing gently.
Remove smaller amounts of dirt with a damp cloth. When doing this, make
sure that wetting of the RollerDrive is no more than slightly damp.
Do not use sharp-edged tools to clean the roller.
Risk of injury due to improper handling or accidental
motor starts
Maintenance work and cleaning may only be executed
by qualified and authorized persons.
Only perform maintenance work after switching off the
power. Ensure that the RollerDrive cannot be turned on
accidentally.
Set up signs indicating maintenance work.
CAUTION
