Interroll Diverter SH 1500
Maintenance and repair
56
Version 1.0 (06/2022) en
Translation of original operating instructions
Maintenance tasks on the ball module conveyor
The ball module conveyor may require the following maintenance tasks to be performed or
parts to be replaced:
• Replace the ball module conveyor,
see "Replacing the ball module conveyor", page 56
• Replace the drum motor,
see "Replacing the drum motor", page 57
• Replace the sprockets,
see "Replace the sprockets", page 59
• Replace return wheel (outside),
see "Replacing the return wheel (outside)", page 60
• Replace return wheel (center),
see "Replacing the return wheel (center)", page 61
• Replace the idler pulley,
see "Replacing the idler pulley", page 62
• Replace the guide plate,
see "Replacing the guide plate", page 63
Replacing the ball module
conveyor
1
1
2
2
4
5
3
3
Ball module conveyor path
1
Idler pulley
4
Drum motor
2
Outside return wheel
5
Ball module conveyor
3
Center return wheel
DANGER
Danger to life from electrocution and crushing
Installation and maintenance tasks on 400-V conveyor systems while they are in operation can
cause life-threatening electrocution and serious crushing.
4
Power down the entire conveyor module and ensure that it cannot be started accidentally.
Requirement:
R
The module is shut down.
4
Drive the connecting rod out of the module conveyor (5) with a hammer and mandrel.
4
Thread out the old module conveyor mat and properly dispose of it.
4
Guide the new module conveyor (5) around the idler pulleys (1) and return wheels (outside)
(2) and thread it in above the center return wheels (3) and around the drive drum (4).
4
Combine the module conveyor without sagging and drive in the connection rod using a
hammer and mandrel.
