Interroll Diverter SH 1500
Maintenance and repair
Version 1.0 (06/2022) en
Translation of original operating instructions
63
Requirement:
R
The module is shut down.
4
Remove the ball module conveyor,
see "Replacing the ball module conveyor", page 56
.
4
Remove the side covers,
see "Removing/installing the side plates", page 51
.
4
Take the idler pulley at the front and rear out of the side frames: Unscrew screws (1) on the
right and left in the side frames (2) and take the idler pulley (3) out to the side.
4
Properly dispose of the old idler pulley.
4
Place new idler pulley (3) between the side frames (2) and fasten with screw (1) on the right
and left at the side frames from the outside.
4
Reattach side covers and ball module conveyor in reverse order.
Replacing the guide plate
1
1
2
3
2
3
Replacing the guide plates
1
Torx screw
3
Transfer plate
2
Guide plate
